3DM2™ Online Help

Table of Contents Previous Next Index


Configuring Units > Adding a Drive
Adding a Drive
If you have a hot swap bay or an enclosure with removable trays, you can add a drive to your system and make it available through 3DM2 without powering down the system.
Without hot swap bays, you should not add a drive via 3DM2. Instead, power down the system and add the applicable drives.
 
* 
Warning: Physically adding a drive without using a hot swap bay and without powering down your system can result in a system hang or may even damage the system and the drive.
 
* 
Note: When you add a drive to your system and connect it to the controller, it is automatically detected and listed in 3DM2. If it does not immediately display, or if it is part of a unit, you can use the rescan feature, as described below.
To add a drive
1
Insert the drive into the hot swap bay or into your enclosure.
For details, refer to the documentation for your enclosure.
2
In 3DM2, choose Management >> Maintenance.
3
On the Maintenance page, click Rescan Controller.
The drive will appear in the list of available drives. You can now use it in a new RAID configuration, as part of an existing configuration, or as a replacement drive in the event that another drive degrades.
If you want to use this drive as a spare, see Creating a Hot Spare.
Table of Contents Previous Next Index
LSI Corporation

Copyright LSI 2004-2010
To contact Support, go to http://www.lsi.com/channel/ContactUs